Contents     Functions         Previous Next     PDF Index

beam1, beam1t


Element functions for a 12 DOF beam element. beam1t is a 2 node beam with pretension available for non-linear cable statics and dynamics.



In a model description matrix, element property rows for beam1 elements follow the format

 [n1 n2 MatID ProID nR 0 0 EltID p1 p2 x1 y1 z1 x2 y2 z2]


n1,n2node numbers of the nodes connected
MatIDmaterial property identification number
ProIDelement section property identification number
nr 0 0number of node not in the beam direction defining bending plane 1 in this case {v} is the vector going from n1 to nr. If nr is undefined it is assumed to be located at position [1.5 1.5 1.5].
vx vy vzalternate method for defining the bending plane 1 by giving the components of a vector in the plane but not collinear to the beam axis. If vy and vz are zero, vx must not be an integer. MAP=beam1t('map',model) returns a normal vector MAP giving the vector used for bending plane 1. This can be used to check your model.
p1,p2pin flags. These give a list of DOFs to be released (condensed before assembly). For example, 456 will release all rotation degrees of freedom. Note that the DOFS are defined in the local element coordinate system.
x1,...optional components in global coordinate system of offset vector at node 1 (default is no offset)
x2,...optional components of offset vector at node 2

Isotropic elastic materials are the only supported (see m_elastic). p_beam describes the section property format and associated formulations.

Failure to define orientations is a typical error with beam models. In the following example, the definition of bending plane 1 using a vector is illustrated.

  % Map is in very variable direction due to undefined nr
  % This is only ok for sections invariant by rotation
  % Now define generator for bending plane 1
  i1=feutil('findelt eltname beam1',cf.mdl); % element row index
  cf.mdl.Elt(i1,5:7)=ones(size(i1))*[-.1 .9 0]; % vx vy vz


This element has an internal state stored in a InfoAtNode structure where each column of Case.GroupInfo{7}.data gives the local basis, element length and tension [bas(:);L;ten]. Initial tension can be defined using a .MAP field in the element property.

This is a simple example showing how to impose a pre-tension :

 model=femesh('TestBeam1 divide 10');
 model.Elt=feutil('SetGroup 1 name beam1t',model);
 d1=fe_eig(model,[5 10]); 
 model=feutil('setpro 112',model,'MAP', ...
 d2=fe_eig(model,[5 10]); 

 xlabel('Mode index');ylabel('Frequency shift');

Strains in a non-linear Bernoulli Euler section are given by


∂ u
∂ x

∂ w0
∂ x

2 w0
∂ x2

See also

p_beam, m_elastic, fe_mk, feplot

©1991-2012 by SDTools
Previous Up Next