SDT 6.3
November 2010
Key features of the SDT 6.3 release are
- iiplot was significantly enhanced (multi-dimensional scanning, channel label generation, channel selection, ...). The SubToFig command was introduced to ease the automated report generation process.
- fe_curve signal processing and curve generation were extended and integrated into iiplot.
- sensor documentation and robustness was significantly revised to improve ease of use and access for new users (see section 4.3 and fe_sens commands Basis, Laser and WireExp).
- Tutorials on wire frame definition (section 3.1) and basic interpolation (section 3.3.2 and fe_sens('WireExp') were revised).
Key features of FEMLink 3.6 are
- ans2sdt was significantly enhanced in its ability to read CDB files (and some forms of input files). Local coordinates are now supported. Material properties are read more consistently. Partial support of .sub and .cms files was introduced.
- nasread was revised for enhanced PBEAML, PBARL read/write, ASET, GENEL and OEF support, OQG read performance, ...
- ufread has new or improved support of files 776, 791, 1710, 2435, 2467, 2477
OpenFEM
- Significant extensions of the ability to specify fields at nodes, DOFs and integration points were introduced. See section 7.13 (sdtweb('VectFromDir')). Associated fe_mknl commands OrientMap and MapMerge were fully revised.
- elem0 command GaussObserve that supports generation of observation information at Gauss points was extended.
- fe_time underwent many detail improvements. An implementation of the Theta method was added.
- p_beam underwent a major revision to support a wider range of pre-defined sections.
More details are given in
www.sdtools.com/help/rel63.html
Compatibility
- SDT 6.3 is compatible with MATLAB 7.1 to 2010b (7.11). Compiled
platforms are Windows (32 & 64), Linux (32 & 64) and MacOS
(32 & 64). For
earlier releases, see details
- For installation procedures see www.sdtools.com/faq/Release.html.
